Instructions / Assembly

#10X1” SELF

TAPPING

SCREW

IMPORTANT: Make

sure that the inside

edge of the top cover

is securely positioned

over the edge of the

ledges

For 2-piece covers, insert bottom

section into top (fig. 1) so that it

becomes one unit (fig. 2).

Then snap cover into place aligning

tab on bottom of cover with slot in

the top plate of pool (fig. 3) and

secure with a #10 x 1" screw (fig. 4).

6" & 7" TWO-PIECE FULL CONTOURED COVER

Slide inside cover (the cover which will be closest to the inside of the pool)

into position and place outside cover onto top of inside cover aligning the

holes together with cage nut attached to the top plate and secure using the

1/4”-20 x 3/4” screw provided. The two (2) edges of the covers should be

parallel. Before tightening the screws, press the two covers firmly together.

Line up the hole in bottom of cover with the hole in the vertical and fasten

securely using the No. 10 x 1” self tapping sheet metal screw provided.

INSIDE COVER

OUTSIDE FULL

CONTOURED COVER

OUTSIDE

FULL

CONTOURED

COVER

1/4”-20 X 3/4”

STAINLESS

STEEL SCREW

If your pool vertical does not have a hole, simply use the cover

as a template and drill through the vertical using a 9/64"

diameter drill bit, being careful not to damage the pool wall.

#10X1” SELF

TAPPING

SCREW