Instructions / Assembly

INSTALLING RESIN LEDGES ONLY
Attention: You must use the 5/16” x 3/4” OD Stainless
Steel Washers with each Sheet Metal Screw to secure
the top ledges to the top plates. Failure to use the
washers may result in damaged ledges.
Place ledges over the wall with each end resting on a
top plate. Align the set of holes in the top plate as shown
in the instructions for your size pool with the holes in the
ledge and insert the No.12x1/2" Sheet Metal Screw through the washer and
the ledge and into the top plate.
The actual screw holes that are used does not affect the integrity of the
pool. You may use the set of holes that line up best!
The ledge screws should not be tightened until all the
ledges are in place and the pool has been filled with water.
No. 12 x 1/2”
Sheet Metal
Screw
WARNING
LEDGE
PLACEMENT
ENTRY POINT
Your pool is equipped with (3) three special
warning ledges.
The (1) one ledge with a large warning on
top is to be installed by the entry point into
the pool and is not to be obstructed by
any object such as your ladder.
The (2) two ledges with the warning
on the inside are to be placed opposite
the entry point into the pool with the warning
facing the entry point.
THESE WARNINGS ARE NOT TO BE
REMOVED UNDER ANY CIRCUMSTANCES
INSTALLING TOP COVERS
18
FOLLOW THE INSTRUCTIONS BELOW FOR
THE COVERS FOR YOUR PARTICULAR POOL
4", 6" & 7" DELUXE TOP COVERS
These covers don’t require cage nuts or top cover screws.
For pools with the new 1-piece deluxe top covers,
simply snap the cover into place, aligning the tab
on the bottom of the cover with the slot in the top
plate of pool (fig.A only.)
A
26
DANGER
Your pools top ledge was not designed
to be a walk around.
CAUTION EVERYONE WHO USES YOUR POOL
NOT TO WALK OR SIT ON THE LEDGE!