Instructions / Assembly

EZ HOOK LINER INSTALLATION
ATTENTION: An 8 inch cove must be placed
all around the inside of the pool
1. Clear all sticks and sharp objects from an area
near the pool, that is as large as the pool itself.
2. Remove the liner from its carton and unfold
and open the liner.
3. Refold the liner so that it can easily be carried to the
pool and unfold from the outside of the pool.
Check the levelness of the sand in the pool and
make sure that no sharp objects are still in the pool.
4. Place the liner into the pool while holding onto
the top of the wall section of the liner.
5. Place the EZ Hook of the liner onto the top
of the wall around the entire pool.
Temporarily place a few of the top rails
over the liner edging to support and
sturdy the wall. Continue in this manner
around the entire pool.
6. Gently pull on the liner and use a soft bristle
broom to remove as many wrinkles as possible on the bottom of the pool.
7. Start filling the pool slowly with water. Continue pulling gently and working the liner
with a broom as needed. Some wrinkling of the liner may be evident and in no way
affects the structural strength of your pool.
Once the water is filled to a point that the liner is pressed firmly against the wall
install the thru-the-wall skimmer following its instructions.
Then you can fill the entire pool as quickly as desired.
22
EZ HOOK
VINYL LINER
TOP RAIL
POOL
WALL
OUTSIDE VIEW
OF POOL WALL
COVE
BEADED LINER INSTALLATION
1. Clear all sticks and sharp objects from an area near the pool, that is as large as the pool.
2. Remove the liner from its carton and unfold and open the liner. Refold the liner so that it
can easily be carried to the pool and unfold from the outside of the pool. Check the
levelness of the sand in the pool and make sure that no sharp objects are still in the pool.
3. Install the bead receiver onto the top of the pool wall. Temporarily place a few
of the top rails over the bead receiver to support and sturdy the wall.
4. Place the liner into the pool while holding onto the top of the wall section of the liner.
5. Snap the bead of the liner into the bead receiver around the entire pool.
6. Gently pull on the liner and use a soft bristle broom to remove as many wrinkles as
possible on the bottom of the pool.
7. Start filling the pool slowly with water. Continue pulling gently and working the liner with
a broom as needed. Some wrinkling of the liner may be evident and in no way affects the
structural strength of your pool.
Once the water is filled to a point that the liner is pressed firmly against the wall install
the thru-the-wall skimmer following its instructions. Them you can fill the entire pool
as quickly as desired.