Instructions / Assembly

18
HOLD DOWN SHEET
10
1 - The hold-down sheets are inserted lip down
into the bottom rail inside the pool as shown.
2 - Do not bend the hold-down sheet
out of shape.
3 - The sides of each sheet will overlap
the sides of the adjacent sheets.
They form a continuous strip of metal.
The hold-down sheets prevent the pool
from lifting under water pressure.
HOLD DOWN
SHEET
BOTTOM RAIL
END
VIEW
WALL
THIS POINT
OVER CENTER
OF STRAP
HALF
SHEET
LEFT
HALF
SHEET
RIGHT
FULL SHEET
SAMPLE 24x12 HOLD DOWN SHEET LAYOUT
WALL
Overlap
Overlap
THRU-THE-WALL SKIMMER
11
IMPORTANT!! BEFORE CONTINUING WITH THIS STEP
YOU MUST KNOW WHICH TYPE OF THROUGH THE WALL
SKIMMER YOU WILL BE USING WITH YOUR POOL
Your pool wall has cutouts to accomodate both STANDARD SIZE
SKIMMERS (Fig. 2) and DELUXE WIDE MOUTH SKIMMERS (Fig. 1).
If you have a WIDE MOUTH SKIMMER, you will be required to remove the
entire cutout as shown in figure 1. To remove the section, you can use either
tin snips or a hammer and knife as shown in figure 3.
1
LARGE WIDE
MOUTH
SKIMMER
CUT OUT
ENTIRE AREA