Instructions / Assembly

17
3 LAYERS OF
CLOTH TAPE
OR DUCT TAPE
VIEW FROM
INSIDE OF POOL
WALL
SEAM
SKIMMER
INLET FITTING
SKIMMER
RETURN FITTING
Once the wall is closed and screws and nuts are tightened securely, cover
the screw heads on the inside of the pool with 3 layers of cloth tape all the
way from top to bottom of wall. An additional layer of tape should be added
to the inside part of the extended end of the wall.
If the filter inlet and outlet are not used, cover over the pre-scored areas on
the inside of the pool wall with 1 layer of tape.
Cloth tape or duct tape is available through your local pool dealer or hardware store.
EXTENDED
END OF
WALL
PROTECT YOUR LINER
8
3
LAYERS
OF TAPE
RECHECKING YOUR WORK
9
POOL WALL
VIEWED
FROM ABOVE
1 - Measure from
the last strap
to the outer
end of the
pool.
Measurements
in both ends
should be equal.
Also make sure
that the sides of the
pool between the straps
are straight.
2 - Confirm that the strap assemblies are "square" by measuring diagonally
across from the first strap to the last strap.
3 - Make sure that the buttresses on each side of the pool are lined up in a
straight row
Also, the measurements from the center of one strap to the center of the next
one should be 48".
48”
48”
48”
48”
48”
48”