Instructions / Assembly

22
1/4”-20 X 3/4”
STAINLESS STEEL SCREW
2 - Secure using the 1/4”-20 x 3/4” screw
provided.
3 - Slide the outside cover onto the inside
cover. Make sure the inside cover is in
the slot of the outside cover.
#12X1/2” SCREW
1 ON EACH SIDE
4 - Align the holes on the side
of the bottom wrap with the
holes on the top of the vertical.
Secure the cover using the
#12 x 1/2” screws provided.
The two (2) edges of the covers
should be parallel. Before
tightening the screws, press
the two covers firmly together.
4
2
If your pool vertical does not have holes,
simply use the top or bottom cover as
a template and drill through the vertical
using a 9/64" diameter drill bit, being
careful not to damage the pool wall.
Place the bottom cover onto the bottom
of the vertical and align the holes on the
side of the wrap with the holes
on the bottom
of the vertical.
Secure the
bottom cover
using the
#12 x 1/2”
screws
provided.
#12X1/2”
SCREW
1 ON EACH
SIDE
WRAP AROUND
BOTTOM COVER
3