Instructions / Assembly

INCORRECT
CORRECT
POOL
LINER
AIR
SPACE
POOL
LINER
POOL
WALL
EARTH
MOUND
15
STANDARD OVERHANG LINER
1. Clear all sticks and sharp objects from an area near
the pool, that is as large as the pool itself.
2. Remove the liner from its carton and unfold and open
the liner.
3. Refold the liner so that it can easily be carried to
the pool and unfolded from the outside of the pool.
Check the levelness of the sand in the pool and make
sure that no sharp objects are still in the pool.
4. Place the liner into the pool while holding onto the
top of the wall section of the liner. Overhang the
top wall of the liner over the pool wall approximately
4” and hold it by temporarily placing the plastic
edging over the liner and the wall.
Continue in this manner around the entire pool.
5. Gently pull on the liner and use a soft bristle broom
to remove as many wrinkles as possible on the bottom
of the pool. Adjust the overhang of the liner as needed
VINYL LINER
TOP RAIL
PLASTIC EDGING
OUTSIDE VIEW
OF POOL WALL
as you go trying to keep it as equal as possible around the pool.
6. Be sure that the seam of the liner where the wall meets the floor of the
liner is evenly centered in the pool.
7. Start filling the pool slowly with water. Continue pulling gently and working
the liner with a broom, and readjusting the overhang as necessary.
Some wrinkling of the liner may be evident and in no way affects the
structural strength of your pool.
Once the water is filled to a point that the liner is pressed firmly against
the wall install the thru-the-wall skimmer following its instructions. Then
you can fill the entire pool as quickly as desired.
The excess liner material overhanging the wall can either be trimmed later
when the pool is filled, or double folded now to the inside of the pool between
the liner and the wall.
8. Permanently install the plastic edging around the entire pool, not leaving
any gaps.