Instructions / Assembly

If you have a STANDARD SIZE SKIMMER, only remove the inside section
of the cutout, and place duct tape around the remaining scored sections as
shown in figure 2.
14
SMALL
STANDARD
SKIMMER
CUT INSIDE
AREA ONLY
On inside of wall, tape
over holes and slots
that will not be used
with duct tape or any
other cloth tape.
2
If the through wall filter inlet and outlet holes are to be used, remove metal
cutouts by breaking perforations using a knife and hammer as shown.
Refer to skimmer manufacturer's instructions for remainder of skimmer
assembly. Make sure skimmer does not leak as this will corrode the pool
wall and cause a split in the wall that is not covered under the pool warranty.
It is recommended to coat the exposed metal on both sides with a
clear lacquer or nail polish to help resist rust and corrosion.
3
LINER INSTALLATION
9
LINER
CAUTION
YOUR POOL IS DESIGNED TO
PROVIDE AN AMPLE SAFETY
MARGIN WHEN IT STANDS
ON LEVEL GROUND.
FOR THIS PURPOSE A SLOPE
IN EXCESS OF 2 INCHES
IN ANY DIRECTION
WALL TO WALL
IS CONSIDERED OFF LEVEL.
YOUR POOL WARRANTY ONLY
APPLIES TO POOLS
INSTALLED ON LEVEL GROUND
AS DEFINED ABOVE.
ONCE YOU HAVE STARTED TO FILL
THE POOL, DO NOT TRY TO PULL
THE LINER FORCEFULLY.
THE WEIGHT OF EVEN ONE INCH
OF WATER WILL MAKE IT
IMPOSSIBLE TO MOVE THE LINER
WITHOUT DAMAGING IT.