Instructions / Assembly

21
6" & 7" TWO-PIECE FULL CONTOURED COVER
Slide inside cover (the cover which will be closest to the inside of the pool)
into position and place outside cover onto top of inside cover aligning the
holes together with cage nut attached to the top plate and secure using the
1/4”-20 x 3/4” screw provided. The two (2) edges of the covers should be
parallel. Before tightening the screws, press the two covers firmly together.
Line up the hole in bottom of cover with the hole in the vertical and fasten
securely using the No. 10 x 1” self tapping sheet metal screw provided.
INSIDE COVER
OUTSIDE FULL
CONTOURED COVER
OUTSIDE
FULL
CONTOURED
COVER
1/4”-20 X 3/4”
STAINLESS
STEEL SCREW
If your pool vertical does not have a hole, simply use the cover
as a template and drill through the vertical using a 9/64"
diameter drill bit, being careful not to damage the pool wall.
#10X1” SELF
TAPPING
SCREW
8" AND 10” TWO-PIECE WRAP AROUND
TOP & BOTTOM COVERS
INSIDE
COVER
10” WRAP
AROUND
TOP COVER
8” WRAP
AROUND
TOP COVER
1 - Slide the inside cover (the cover which will
be closest to the inside of the pool) into
position and align the hole in the cover with
the cage nut attached to the top plate.
1