Instructions / Assembly

18
PRE-ASSEMBLY OF TOP PLATES*
11
*NOTE: CAGE NUTS NOT NEEDED ON ALL POOLS - CHECK YOUR PACKING LIST
Before the top plates are installed it is necessary
to attach the cage nuts* in their appropriate
locations as shown in the figures at right.
Using a pliers, squeeze together the spring
sides of the cage
nuts and insert
them into the top
plate from
underneath.
PLIERS
TOP PLATE
CAGE NUT
TOP PLATE WITH CAGE NUT
1/4” CAGE
NUT
TOP PLATES AND RAILS
12
PLASTIC
EDGING
RAIL
TOP PLATE
1 - Insert two rails into a plate, in the same manner
and using the same spacing as you have done
on the bottom rail and plate assembly.
2 - Push the rails and plate assembly onto the
plastic edging leaving the far end in the air.
MAKE SURE THAT THE TOP PLATE IS CENTERED
DIRECTLY ON TOP OF THE BOTTOM PLATE.
3 - Attach the vertical to
the top and bottom plate
using the No.12x1/2"
Sheet Metal Screws.
4 - Insert the exposed end
of a top rail into another
top plate with a top rail
inserted into the
opposite side.
5 - Push the top plate with
rails onto the edging
again leaving the far end
of the rail in the air.
6 - Continue in this manner
all the way around the
pool.
No. 12 x 1/2”
Sheet Metal
Screw