Instructions / Assembly

10
INSERT WALL INTO BOTTOM RAILS
3
4’ x 4’ Plywood
SKIMMER
INLET
SKIMMER OUTLET
2 - Determine the starting point as the filter inlet
and outlet holes are at the beginning of the wall.
Make sure that the cutouts for filter inlet
and outlet are on the top portion of the
wall and will not be hidden behind a vertical.
3 - Starting at the center of a bottom plate
insert the bottom edge of the wall into
the groove on the bottom rail.
Ensure that the center line of the closure holes
in the the wall align with the center of the plate.
4 - If the wall ends do not
meet, adjust the bottom
rail in or out of the bottom
plates.
The spacing in all bottom
plates should be equal.
During the manufacturing process, the one end of
the pool wall will have a slight crease or bend in it.
Straighten out this bend as best as possible, and
assemble the pool wall putting this end of the wall
on the outside as shown.
1 - Remove the wall
from carton.
NOTE
the UP
arrow
on the
wall.
INSIDE POOL
OUTSIDE
POOL
POOL WALL
INSIDE
POOL
OUTSIDE
POOL
OUTSIDE
POOL
INSIDE
POOL