SDS

Ultimate Liquid Wax G2105 [G210516]
06/25/20
Page 4 of
9
When only incidental contact is anticipated, alternative glove material(s) may be used. If contact with the glove does occur,
remove immediately and replace with a set of new gloves. For incidental contact, gloves made of the following material(s)
may be used:Nitrile Rubber
Respiratory protection
None required.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Appearance
Physical state
Color
Liquid
Pale Yellow, Soft White
Odor Sweet Orange, Pleasant Odor
Odor threshold No Data Available
pH 8.8 - 9.5
Melting point Not Applicable
Boiling Point 212 ºF
Flash Point >= 200 ºF [Test Method:Pensky-Martens Closed Cup]
Evaporation rate No Data Available
Flammability (solid, gas) Not Applicable
Flammable Limits(LEL) No Data Available
Flammable Limits(UEL) No Data Available
Vapor Pressure No Data Available
Vapor Density No Data Available
Density 0.9 - 1 g/cm3
Specific Gravity 0.9 - 1 [Ref Std:WATER=1]
Solubility in Water Moderate
Solubility- non-water No Data Available
Partition coefficient: n-octanol/ water No Data Available
Autoignition temperature No Data Available
Decomposition temperature No Data Available
Viscosity 10,000 centipoise - 20,000 centipoise
Molecular weight No Data Available
Volatile Organic Compounds 12.5 % weight [Test Method:calculated per CARB title 2]
Percent volatile 93 % weight [Test Method:Estimated]
VOC Less H2O & Exempt Solvents 593 g/l [Test Method:calculated SCAQMD rule 443.1]
SECTION 10: Stability and reactivity
10.1. Reactivity
This material is considered to be non reactive under normal use conditions.
10.2. Chemical stability
Stable.
10.3. Possibility of hazardous reactions
Hazardous polymerization will not occur.
10.4. Conditions to avoid
None known.
10.5. Incompatible materials