User Manual

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [e-mail]
Page 16
NO.
Setup instructions
NO.
Setup instructions
1
Auto-control rudder surface reverse
10
circling radius setting
2
Control gain
11
Farthest flight distance setting
3
ailerons
12
Airspeed adjust setting
4
Elevator
13
Rudder mixing mode
5
Throttle
14
Initialize gyroscope
6
Rudder
15
Initialize air speed sensor
7
Three-switch mode selection
16
Save the settings
8
FY-41AP install setting
17
Exit the Settings interface
9
Cruising speed setting
Method two: Setting FY-41AP via “FYGCS 5.11 for FY41AP and Dos”
software
(1) Please visit the official website: www.feiyu-tech.com. Download the newest USB
driver at the download page
(2) After successfully install the USB driver, insert the USB-TTL interface cable into
computer USB COM port(don‘t connect TTL port to any other device ) , the system will
correctly identify the USB -TTL data cable, then you will find there is more than one
port(COM and LPT).
If the USB data cable you have received is the new one(Silver), like the picture show,
please download the ―Feiyu Tech New USB Driver ‖.The new port is ―Silicon Labs
CP210x USB to UART Bridge‖.
If the USB data cable you have received is the old one(Black), like the picture show ,
please download the ― USB Driver ‖.The new port is "Prolific USB-to-Serial Com Port"
The “COM * ” is the virtual serial number of the USB-TTL cable.
1 ) Install Google Earth plug-in 6.1 version or above.
Two methods to install the plug-in .
Method one: Networking installed directly.
Method two: Install the local plug-in provided by us , you can download at our