User Manual

Guilin Feiyu Technology Incorporated Company.
http://www.feiyu-tech.com [e-mail]
Page 20
Method two: Setting FY-41AP Lite via “FYGCS 5.11 for 41&DOS” software
Step Three: The remote control switch setting & checking
and setting the direction of the rudder surface automatically
control .
FY-41AP Lite requires a minimum of 6-channel RC receiver.
1) First, the remote control is set to fixed-wing aircraft of conventional layout mode,
do not set any mixing. The rudder angle of the remote control is set to 100%, and
fine-tune gyrus.
2) Need two three-position switch or rotary switch settings for CH5, CH6 used to
connect SW1 and SW2. Use for switch the flight mode.
3) Connection is completed, switch CH5, CH6 to check the settings whether can
correct setting control mode. Also you can confirm it via the status of the lights, or
OSD display mode.
4) Switch to manual mode, check the control surfaces of the joystick remote control
aircraft direction whether is correct, if not correctly, adjust the rudder surface reverse
control on the remote control to correct it.
5) Switch to the "Auto Balance Mode", check the control direction according to the
following steps carefully.