User Manual

Guilin Feiyu Technology Incorporated Company.
http://www.feiyu-tech.com [e-mail]
Page 16
NO.
Setup instructions
NO.
Setup instructions
1
Auto-control rudder surface reverse
10
Circling radius setting
2
Control gain
11
Farthest flight distance setting
3
Ailerons
12
Airspeed adjust setting
4
Elevator
13
Rudder mixing mode
5
Throttle
14
Initialize gyroscope
6
Rudder
15
Initialize airspeed sensor
7
Three-switch mode selection
16
Save the settings
8
FY-41AP Lite install setting
17
Exit the Settings interface
9
Cruising speed setting
Method two:
Setting FY-41AP Lite via “FYGCS 5.11 for 41&DOS” software
1 ) Please visit the official website: www.feiyu-tech.com. Download the newest setting
software “FYGCS 5.11 for 41&DOS” and the USB driver at the download page which
related to FY–41AP Lite products.
2 ) After successfully install the USB driver, insert the USB-TTL interface cable into
computer USB COM port(don’t connect TTL port to any other device ) , the system will
correctly identify the USB -TTL data cable, then you will find there is more than one
port(COM and LPT), the port COM6 in the “Silicon Labs CP210x USB to UART Bridge
(COM6)” is the Virtual serial number.
Inserter a few times for confirmation the virtual serial number. After that, you can use
the new USB data cable normally.
3 ) Install the software “FYGCS 5.11 for 41&DOS”. The software in addition to can use
for setting up and configuring FY-41AP Lite also included other functions. For example,
Electronic mapping, Telemetry data monitoring of flight parameters, Flight attitude, Flight
speed, Altimeter, Location, Recording and Playback of telemetry data into Ground
Control Station, Map loading ,etc .
a) Double-click “ ” installed by default.
b) After installation, double-click “ ” to open the FYGCS5.11 software,
you can see the following interface.