Instructions / Assembly

3" TYP GAP
BETWEEN DRUMS
1/8" hole 1" up
from bottom of Drum
Anchor Disc
Portable Stand
2" Tamper-
Resistant Screw
Tuned Drum
BB
Check for clearance
between 2" Screw
and Socket Cap Bolt
90° TYP
PORTABLE MOUNT INSTALLATION PROCEDURES
Step 1:
Install the Drums over the corresponding Anchor Discs. Predrill (4) 1/8" holes in a 90
cross pattern, 1" up from the bottom of the drum. Drill through
both Drum and Anchor Disc. When predrilling holes, make sure they clear the preinstalled Socket Cap Bolt , and that there is clearance for the 2"
screws to be installed without interfering with the other drums.
Step 2:
Secure Drums to Discs with the provided 2" Tamper-Resistant Screws.
Step 2:
Check for sufficient clearance around instruments. A 36" clearance is recommended around the the entire Drum arrangement for wheelchair
accessibility, however this is not required for proper function. Drums may also be installed next to a wall or in a variety of different configurations.
Step 3:
Remove plastic film from drum caps if applicable.
NOTE:
When transporting the Tuned Drums, uninstall them from the Portable Stand. This will prevent the possibility of damaging the Drums and/or Anchor Discs.
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
FREENOTES HARMONY PARK. ANY
REPRODUCTION IN PART OR AS A WHOLE
WITHOUT THE WRITTEN PERMISSION OF
FREENOTES HARMONY PARK IS
PROHIBITED.
FREENOTES HARMONY PARK
194 BODO DRIVE, UNIT F
DURANGO CO 81303
TEL: [phone]
FAX: [phone]
EMAIL: [e-mail]
WWW.FREENOTESHARMONYPARK.COM
SHEET 5 OF 5
SCALE: 1:16
PRODUCT SHEET / INSTALLATION GUIDE
TUNED DRUMS 2016