Instructions / Assembly

3
3
8
" or Less
9" or Greater
6" of concrete
Finished Height
68
3
4
" min. pad
26
3
4
"
min.
pad
1/8" hole 1" up
from bottom of Drum
1/4" x 3 1/4"
Anchor Bolt
Anchor Disc
2" Tamper-
Resistant Screw
Tuned Drum
AA
90° TYP
Check for clearance
between 2" Screw
and Anchor Bolt
SURFACE MOUNT INSTALLATION PROCEDURES
Step 1:
Arrange Drums in desired location and pattern. Drums can be laid out in any configuration desirable, but must be installed less than 3" or greater
than 9" apart. WARNING: Between 3" and 9" there lies a chance for a child's head to get stuck. (Reference: US Consumer Product Safety Commission,
Public Playground Safety Handbook). Mounting surface should be level.
Step 2:
Once you have decided your layout, replace drums with the provided Anchor Discs. Mark holes on the concrete through the (3) holes on all of the
Anchor Discs. Set aside Discs, drill 1/4" holes 2" into concrete at marked locations. ( A 1/4" masonry drill bit will be needed ) Contractor to provide a
concrete slab that will perform under local soil and weather conditions. (If anchoring to a material other than concrete, fasteners to be provided by
the customer)
Step 3:
Place the Anchor Discs back over the drilled out holes. Insert provided anchor bolts into aligned holes. Position anchor nut so that it is flush
with the top of the bolt. Pound anchor bolts into the hole until the anchor washer is flush with the post base. Tighten anchor bolts until they are snug.
Step 4:
Install the Drums over the Anchor Discs. Predrill (4) 1/8" holes in a 90
cross pattern, 1" up from the bottom of the drum. Drill through both Drum and
Anchor Disc. When predrilling holes, make sure they clear the previously installed anchor bolts, and that there is clearance for the 2" screws to be
installed without interfering with the other drums. Secure Drums to Discs with the provided 2" Tamper-Resistant Screws.
Step 5:
Check for sufficient clearance around instruments. A 36" clearance is recommended around the the entire Drum arrangement for wheelchair
accessibility, however this is not required for proper function. Drums may also be installed next to a wall or in a variety of different configurations.
Step 6:
Remove plastic film from drum caps if applicable.
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
FREENOTES HARMONY PARK. ANY
REPRODUCTION IN PART OR AS A WHOLE
WITHOUT THE WRITTEN PERMISSION OF
FREENOTES HARMONY PARK IS
PROHIBITED.
FREENOTES HARMONY PARK
194 BODO DRIVE, UNIT F
DURANGO CO 81303
TEL: [phone]
FAX: [phone]
EMAIL: [e-mail]
WWW.FREENOTESHARMONYPARK.COM
SHEET 4 OF 5
SCALE: 1:22
PRODUCT SHEET / INSTALLATION GUIDE
TUNED DRUMS 2016