Installation Guide

ASSEMBLY INSTRUCTIONS:
1. Unscrew three (3) Locking Screws from the bottom of the
Fan Body.
2. Pass the Power Cord through the center hole of the Fan
Base, and firmly snap the two halves of the Fan Base
together.
3. Secure the Fan Base to the Fan Body with the Locking
Screws from Step 1. Tighten the Locking Screws firmly.
4. Place the Power Cord through the cut out on the bottom of
the Fan Base.
OPERATING INSTRUCTIONS:
1. Set the Fan Base on a dry, level surface.
2. Plug cord into any standard 120 volt AC outlet. Make sure
the Speed Control Switch is in the ‘0’ (Off) position.
3. The SPEED is adjusted by turning the Speed Control
Switch to 1, 2 or 3.
4. This fan has OSCILLATION function. Turn the Speed
Control Switch to the left side for oscillating function.
CLEANING AND MAINTENANCE INSTRUCTIONS:
WARNING:
 Always unplug from electrical supply source before cleaning.
 Do not allow water to drip on or into the fan motor housing.
 Be sure to use a soft cloth moistened with mild soap solution. Do not use harmful cleaners.
Cleaning
Plastic parts shall be cleaned with mild soap and a soft, moist cloth or sponge. Thoroughly remove soap film with
clean water.
User Maintenance
This fan is permanently lubricated and will not require additional lubrication (oil) for the life of the fan. This fan
requires little maintenance and contains no user serviceable parts. Do not attempt to repair or adjust any electrical or
mechanical functions on this unit.
USER SERVICING INSTRUCTIONS:
If the fuse blows, replace it as follows:
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
2. Open fuse cover. Slide open fuse access cover on top of attachment plug towards blades.
3. Remove fuse carefully.Push the fuse from the other side or turn fuseholder over to remove fuse.
4. Risk of fire. Replace fuse only with 2.5 Amp, 125 Volt fuse (provided with product).
5. Close fuse cover. Slide closed the fuse access cover on top of attachment plug.
Fan Parts:
A. Speed Control Switch
B. Fan Body
C. Fan Base
D. Locking Screw
E. Power Cord
Non-Oscillating
Oscillating