Use and Care Manual

Page 6 of 8
container before lighting the unit. In case of fuel spillage in the
overflow container, remove the burner box, wipe completely with a dry
absorbent cloth and replace the burner into the overflow container before
lighting the unit.
- Recommended minimum clearances:
Overhead: 60cm (24in)
Front: Accessible at all times
CAUTION: Risks of burns. Do *not* operate the unit without the protective
glass guard completely attached. Wait 20 minutes after the burner has gone
out before touching or removing the protective glass.
WARNING
DO NOT PACK REQUIRED AIR SPACES WITH INSULATION OR OTHER MATERIALS.
Maintenance
Only use a damp clean cloth to clean the unit. Never use chemical cleaning
products, scrubbing powder, steel wool, or hard sponges to clean the unit
as it may damage to the unit;
IMPORTANT: The warranty does not cover risks of rusting. Always keep the
unit away from continuous rain and/or excessive humidity; Keep in mind to
always properly dry the unit after cleaning it with water;
PERIODIC SERVICE REQUIREMENT: VERIFY OPERATION OF MANUAL SHUTOFF DEVICE.
Free Standing Installation
Eco-Feu does not supply the anchoring screws. It is up to the owner and
installer to purchase the proper screws for the type of stud they will be
screwing into.
ALWAYS CONSULT A QUALIFIED CONSTRUCTION
PROFESSIONAL WHEN MAKING MODIFICATIONS TO ANY WALL
1. Anchorage
a. Taking into account the General Safety Precautions and
Installation Requirements mentioned above, designate an
appropriate location for your free standing unit.
b. Use the proper screws and washers to anchor the base of the unit
via the 4 screw holes(a) to the floor. Access the anchoring
holes through the burner slot(e).
2. Burner Installation
a. Place the burner(4) into the overflow container(3). Make sure
the burner is stable and levelled with the control arm on the
correct side.
b. Remove the control arm handle(7) by unscrewing it. Carefully
place the overflow(3) into the designated slot(e).
c. Reattach the control arm handle by screwing it in firmly through
the opening(f).
d. Make sure the burner shutter, opens and closes smoothly by
moving the control arm shutter handle left and right.