User Manual

FRF3_EVO Brushed flight controller integrated FRSKY RX

Connection Diagram:

M1/M2/M3/M4 connect to the coreless motor

BAT connect to the battery (1S 3.7V Lipo battery)

BEEP connect to the buzzer

LED +5V GND connect to the WS2812 LED

Binding procedure:

1. Turn on the transmitter , select D8 mode for the Receiver.

PAGE 1
FRF3_EVO Brushed flight controller integrated FRSKY RX Connection Diagram: M1/M2/M3/M4 connect to the coreless motor BAT connect to the battery (1S 3.7V Lipo battery) BEEP connect to the buzzer LED +5V GND connect to the WS2812 LED Binding procedure: 1. Turn on the transmitter , select D8 mode for the Receiver.
PAGE 2
. Jumped the two bind pins on the board and then connect the battery, the Blue led is solid. 3. Go to the Receiver [Bind] option, and ENT to Bind with the receiver, The transmitter beeps. 4. The Blue LED on the receiver will turning off, this indicates that the bind process was successful. Reconnect the battery to the flight controller, and the Blue LED on the receiver is solid again. ARM/DISARM the motor 1. Turn on the transmitter and move to the MIXER interface, Set “SA” or “SB” switch etc.
PAGE 3
2. The default configuration was set AUX1(CH5) to ARM/DISARM the motor before shipping, you can also customize it. The default receiver channel map is TAER1234, please ensure your transmitter is matched with it, otherwise it can't be armed. 3. Toggle the Switch SWA and the blue LED on the flight controller will get be solid, this indicate the motor was armed ,enjoy yourself now and be careful ! 4.