User Manual

AEO TECHNOLOGY www.aeorc.com
Entire Contents © Copyright 2010
4
4. Setting：
4.1 Explanation about the button ：
Five direction button：
Long push the button will enter or exit
the setting interface ,put it up pr down will
choose the setting items ,push it right or
left will set the item you choose ,short push
will confirm what you have set .
4.2 Confirm selection：
The lighter one is the option has
been chosen
4.3 Head movement tracking system
setting options (options1-6)
“X REX”“Y REX”show the
positive direction of X axis and Y axis , and
“NOR”shows they have the same
direction.
“X GAIN”“Y GAIN” are the
sensitivity adjustment of X axis and Y axis
ranging from1%to100%，1% is the lowest,
means inverse ratio , 100% is the highest
means direct ratio .
“X TRN”“Y TRN” are for
adjusting X and Y axis corresponding to
the servo’s neutral point .ranging from -100
to +100.
4.4 Mode switch setting (ption7)
When display“Mode1”,Mode2 is
closed .When there is only one mode ,the mode switch won’t work.
When the displaying content is output channel array . then the corresponding channel becomes its
mode switch.
For example , MOD SW = C7,means mode1/2 switch is the seventh channel on interface C ,When
setting MOD SW = AX , represents mode1/2 switch is the movement on X- axis of the head movement
tracking system on interface A.
4.5 Reset the head movement tracking system setting (option8)
When display“BTN” ,reset switch is short push of the button on System1.5.,
When the displaying content is the output channel array ,then the corresponding channel becomes the
mode switch.
For example , RST SW = C7means the reset button is the seventh channel on interface C.
4.6 set state under mapping select mode1（option9-16）：
Under mode 1,receiver’s 8 channels is controlled by the corresponded output channels on the
transmitter
4.7 set state under mapping select mod2（option17-24）：
Under mode2,receiver’s 8 channels is controlled by the corresponded output channels on the transmitter
4.8 option25,wiil turn everything into default setting ,displaying as default setting.