User Manual

AEO TECHNOLOGY www.aeorc.com
Entire Contents © Copyright 2010
2
2. Connecting way：
2.1 Connect main transmitter：
System wires：a main signal wire ,two FUTABA connecting wires for different interfaces and one
FUTABA connecting wire used for providing power.
If the transmitter need to be connected is FUTABA series 12FG(included),you can use square plug
cables(collocated with FF9,6EX-AP) or round plug cables(collocated with T9Z、FF7、FF8)to connect it to
coaching interface .Then connect to interface B on System1.5 by the main signal wire .as the following
picture shows:
If your device is FUTABA high-end device such as T12MZ T14MZ , you can also connect the whole
system as what said above ,because of the different interfaces, you need to use a separated connecting wire
to connect System 1.5(interface B) with another 7-12V battery(two low capability batteries are suggested) as
the following picture shows:
2.2 connect auxillary operators：
transmitters： same as the way the main transmitter is connected ,use the main signal wire to connect
transmitters to the interface C or D on System1.5.
simulate operators：connect to interface C or D on System1.5
2.3 connect head movement tracking system：
Connect the only interface of head movement tracking system to interface A on System1.5.