Use and Care Manual

INSTALLATION
This section provides step-by-step instructions for installation of your heater.
WARNING
The outlet must be 15A/120V.
CAUTION
Do not remove the four rubber feet at the bottom of the heater or install the heater directly on soft
surfaces, which may restrict air circulation. Otherwise, it may cause a risk of fire or damage.
1. Select a suitable location, which is not susceptible to moisture, safe, dust free, away from high traffic and
away from things may catch fire or block openings such as drapes, furniture, etc.
NOTE
This heater is for household use only.
It is a good idea to place your heater near an existing outlet, for ease of electrical hook up.
2. Place the heater in the desired location to see how it will look in the room.
3. The size is: Wide+2CM ×High+2CM ×Deep+2CM
4. If there's no 15A/120V outlet near the desired location, install a new one .
WARNING
Do not attempt to wire you own new outlets or circuits. To reduce the risk of fire, electric shock
or injury to persons, always use a licensed electrician.
5. Make sure the heater is switched off (refer to operation instruction section).
6. Plug the heater into a 15A/120V outlet. Wiring the cord along the corner of wall.
Plug must be accessible after installation.