PRACTICAL USER'S GUIDE FOR THE ELECTRIC FIREPLACE
QUICK REFERENCE GUIDE I. II. III. Prior to installation, please ensure: 1. The rated voltage of your heater fits the output voltage of your outlet; 2. The light bulbs in your heater is in good condition. For checking this, please follow the instructions for replacing the light bulbs on section MAINTENANCE. The heater on your electrical fireplace may emit a slight, harmless odor when first used. This odor is a normal condition caused by the initial heating of internal heater parts and will not occur again.
IMPORTANT INSTRUCTIONS WARNING You should read and always follow the important instructions below to reduce the risk of fire, electric shock, and injury to persons. 1. Read all instructions before using this heater. 2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces, such as surfaces near the heater outlet or light bulbs. The grill directly in front of the heater outlet becomes hot during heater operation. If provided, use handles when moving this heater .
22. When transporting or storing the heater and cord, keep in a dry place, free from excessive vibration and store so as to avoid damage. 23. The heater must not be located immediately below a socket-out. 24. WARNING: In order to avoid overheating, do not cover the heater. 25.
INSTALLATION This section provides step-by-step instructions for installation of your heater. WARNING The outlet must be 15A/120V. CAUTION Do not remove the four rubber feet at the bottom of the heater or install the heater directly on soft surfaces, which may restrict air circulation. Otherwise, it may cause a risk of fire or damage. 1.
OPERATION This section will explain the function of each convenient control. NOTE The heater may emit a slight, harmless odor when first used. This odor is a normal condition caused by initial heating of internal heater parts and will not occur again. Control Panel Operation A.
and is dark. When the heater is not in low-power status ( is dark), press button will switch it to low-power status; when it's in low-power status ( is brighten up), press button will turn it off. Similarly, a button press will switch the heater to high-power status when is dark, and turn it off when is brighten up. Note, before the heater emits heat or after it stop producing heat, the hot air outlet may output air for 10 seconds.
MAINTENANCE WARNING Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock to persons or damage. Light Bulb Replacement Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log exterior disappears. WARNING Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid burning of skin.
Correct Disposal of this product This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.
