User Manual

2
1. Summary
1.1 Introducing
The Flymentor 3D is consist of three modules, Controller, Sensor and CCD. See
Diagram1.1.1.
Diagram1.1.1 Flymentor 3D modules
Device Connector
USB Port
LED
Sensor
CCD
Receiver
Connect Line
Controller
·Controller: it is kernel of Flymentor 3D, and takes charge of balance calculating and servos
controlling. The Receiver Connect Line is used to link receiver to obtain signal. The Device
Connector is used to link servos to control them.
·Sensor: It is used to induce the position of helicopter, and transform the signal to controller.
Sensor must be mounted on suitable place. Usually, the Sensor should be mounted on the
KDS Flymentor 3D User Manual
07-17-平衡仪说明书(英文).pdf 5 2009-8-3 15:06:1007-17-平衡仪说明书(英文).pdf 5 2009-8-3 15:06:45