User Manual

13
3.2 Mounting Flymentor 3D
Firstly you should find a suitable place to mount Flymentor 3D. The lens of CCD should face to
the ground, and the Sensor should be mounted on the place where gryo was assembled,
see diagram 3.2.1 for example. The controller can be mounted in any place you want.
Diagram 3.2.1 mounting exampleA
*Attention: the arrow on CCD and the arrow on Sensor must point to same direction
Mount CCD at side of
helicopter, lens face to
the ground, the arrow point
to front.
Mount Sensor on flat at tail
(or bottom of flat),the arrow
point to front.
After mounting of Flymentor 3D, all electronic devices should be connected. There is a
internal gyro in Flymentor 3D, so additional gyro is not necessary. Diagram3.2.2 is an
example, the connection between receiver and controller should refer to following table.
KDS Flymentor 3D User Manual
07-17-平衡仪说明书(英文).pdf 16 2009-8-3 15:06:46