User Manual

12
be 100% (you may set some EXP to make better feel) , the signal should be set to 1.5ms
neutral. If you are using the built-in gyro of Flymenotor 3D, all mixers related to rudder must
be turned off.
Diagram 3.1.1 Ensure no mixing mode
Reciever
BEC
Battery
*Attention: it is FUTABA remote system, if you are using JR remote system, please link
servo to 2/3/4/6 channel.
To ensure you have turned off all mixer properly, you should make a test system like
diagram3.1.1 when you haven` t connected with the flymentor 3D. After powering up, move
the stick on, if the four directions of the two sticks affects only one servo, that prove the mixers
are all turned off successfully.
Please read manual of transmitter carefully before operating.
KDS Flymentor 3D User Manual
07-17-平衡仪说明书(英文).pdf 15 2009-8-3 15:06:46