User Manual

Set Tx swash type to 1 servo, or H1
Aileron,Elevator trims and subtrims to 0,
End point to 100% and servo reverses to normal, except the throttle channel
leave that at it is.
Set a linear pitch curve 0-25-50-75-100.
The plug with 3 wires from the FM module connects to the aileron portion the
Rx
Yellow connects to Elevator port,
Orange connects to pitch port.
If you are using the FM tail gyro
Gray wire connects to the rudder port,
Green connects to the gyro gain port.
If you are using a separate tail gyro leave it connected as it is to the Rx,
and leave the gray and green wires disconnected.
The blue wire controls stabilization gain and is best left disconnected during set
up.
If the elevator servo is rear mounted, looking at the helicopter from the rear .
The left hand servo connects to port 1 on FM,right hand servo to port 2 and
elevator to port 3.
The black negative wire on the servo leads are closest to the USB port and line
up with the USB sign.
If the elevator servo is front mounted,
The left servo to port 2 and right servo to port 1.
Leave the blue wire from the FM gyro disconnected for now.
If you are using the FM tail gyro connect tail servo to port 5 on FM.
Disconnect motor, power up TX and Helicopter,
LED on FM should be flashing green, and connect to Helibal Program