User Manual

ManualsBrandsUnbranded ManualsAircraftFlymentor 3D helicopter stabilisation System

This was written by Ivor Hill to help all those who are

interested in using the KSD Flymentor system

PLEASE....

Read though this first before asking hardware setup questions.

Any questions please post them in the FLIGHT Stabilization Forum as to not

clutter the sticky.

Thank you!!! Freaks

This should answer and/or solve most of the installation issues associated with

the KDS FlyMentor System..

Any issues concerning software installation on a PC or radio system being

used should be brought up on the main Forum to be answered.

Summary of content (4 pages)

PAGE 1
This was written by Ivor Hill to help all those who are interested in using the KSD Flymentor system PLEASE.... Read though this first before asking hardware setup questions. Any questions please post them in the FLIGHT Stabilization Forum as to not clutter the sticky. Thank you!!! Freaks This should answer and/or solve most of the installation issues associated with the KDS FlyMentor System..
PAGE 2
Set Tx swash type to 1 servo, or H1 Aileron,Elevator trims and subtrims to 0, End point to 100% and servo reverses to normal, except the throttle channel leave that at it is. Set a linear pitch curve 0-25-50-75-100. The plug with 3 wires from the FM module connects to the aileron portion the Rx Yellow connects to Elevator port, Orange connects to pitch port. If you are using the FM tail gyro Gray wire connects to the rudder port, Green connects to the gyro gain port.
PAGE 3
Check that swash type,blade direction and gyro camera directions are set correctly under the Helibal mounting tab. Tip the helicopter and under the servo tab set the servo directions and send to FM so that when the helicopter is tipped, the swash moves to correct in the opposite direction. If you can get aileron to operate, but not elevator the swap servo connections on FM ports 1 and 2 and start again. Check stick directions and any that are incorrect reverse under the control tab and send to FM.
PAGE 4
You may also need to use a little TX trim to stop the helicopter drifting. If you are using the FM tail gyro, You will first need to switch it to normal mode with a gain value of about 25, either with your TX if the green wire is connected or by using the slider on the tail page in Helibal if the green wire is disconnected.