User Manual

15
3.3 Adjusting 'Mounting parameters'
The page 'Mounting' is some basic parameters relate to mechanism, they must be configured
correctly so that Flymentor 3D can work. The interface is shown as diagram 3.3.1, there are
three categories: mounting direction, rotor direction, swashplate type.
Diagram 3.3.1 'Mounting' page
1) Mounting orientation
There is an arrow printed on Sensor and CCD of the Flymentor 3D. You can point the
arrow to any direction when mounting, but the two arrows must point to same
direction (and lens of CCD must face to ground). Normally, the arrows point to
front (helicopter head). After mounting, you should set this parameter according to the
are
KDS Flymentor 3D User Manual
07-17-平衡仪说明书(英文).pdf 18 2009-8-3 15:06:46