User Manual

After resolving all hardware and software problems, the other one was the configuration
from KDS Flymentor and my Eurgle V1=(Turnigy) Tansmitter.
I´ve installed HK929MG, with the normal setup there is no normal operation posible
“Servos getting crazy”
So I´ve reduced sensibility of sensor in “Advance”; I´ve changed for a normal stable fly in
Horizontal and Position mode: Total sensor gain to 4, Stick sensivity gain to 4, Position
sens. gain to 6; this is not perfect for Position mode but suitable
For selecting “flying mode” AUX-CH, ch7 - Pitch trim
NO EXTRA GYRO by mixing both Flymentor and Transmitter, don´t know why, but it works
nearly great. In my case in Flymentor: Gyro sense -60, servo tail limit 43, 0 pitch tail mix,
and Sensor gain on 3, I only know is to regulate frequence of the servo and on Transmitter
I´ve got Nor 60, Gyro active.
Receiver settings: 3color- ch1, orange-ch2, ESC-ch3, gray-ch4, green-ch5, yellow-ch6, blue-
ch7. Mounted on Flymentor the same as Software servo1-front left, servo2-front right
servo3-back
Balancer Software;
Servo: S1-Rev, S2-Nor, S3-Rev, Tail servo-Rev
Control: all Nor; Travel 100
USB FIX TO COMPUTER, TRANSMITTER AND RESEVER ON, THAN START BALANCER, AND
NOW I´M CONECTING TO FLYMENTOR , BALANCER Software will recognize it immediately.
My system is windows 7, configuration from Heli – Flymentor will not be recognized, so you
to save and to load it at first to going on with configuration. In Windows XP no problem at
all.