User Manual

“KDS Flymentor mounted in a HK450v2 with a Eurgle V1 Transmitter”

Now, the first was that <USB> connector was not recognized. NO RED

LIGHT

First solution is “resold” usb-connector.

USB input will be recognized immediately, select KDS and install driver in all windows

version (no problem) , select com, disconnecting all usb and in properties select com3 or

something alls. Install KDS software.

Second problem I have to “resoled” Flymentor box (input side), because they didn´t

recognize optical sensor (error blinking)

PAGE 1
“KDS Flymentor mounted in a HK450v2 with a Eurgle V1 Transmitter” Now, the first was that connector was not recognized. NO RED LIGHT First solution is “resold” usb-connector. USB input will be recognized immediately, select KDS and install driver in all windows version (no problem) , select com, disconnecting all usb and in properties select com3 or something alls. Install KDS software.
PAGE 2
After resolving all hardware and software problems, the other one was the configuration from KDS Flymentor and my Eurgle V1=(Turnigy) Tansmitter. I´ve installed HK929MG, with the normal setup there is no normal operation posible “Servos getting crazy” So I´ve reduced sensibility of sensor in “Advance”; I´ve changed for a normal stable fly in Horizontal and Position mode: Total sensor gain to 4, Stick sensivity gain to 4, Position sens.