User Manual

2. Select RX setup to AFHDS Mode, turn on the transmitter while holding the bind button, use
the Flysky I6 as an example. The Blue led on the flight controller will getting to be solid ,this
indicates binding successful
3. Reconnect the battery, the green LED on the receiver flash fast again, this indicates Receiver
and Transmitter are all works
ARM/DISARM the motor
1. Turn on the transmitter and move to the AUX. Channels interface, Set “SWA” or “SWB”
switch etc. for CH5 to ARM/DISARM the motor, USE FLYSKY I6 as an example.
2. The default receiver channel map for flysky version is AETR1234, please ensure your
transmitter is matched with it, otherwise it can't be armed.