Installation Instructions
LED Panel Light InstallationInstructions
Thanks for using our products. Please read these installation i nstructi ons
before installing the luminaire, and keep them for future reference.
Warning
• Luminaire must be installed, checked and repaired by an authorized
electrician.
• This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and
operation of the product and the hazards involved.
• For proper operation, make sure to connect the luminaire to the
proper voltage and install it according to these instructions.
• For safety purposes, cut off the power and allow the luminaire to cool
before installing or removing it.
• Don’t install the panel light to an unstable ceiling or near combustible
materials.
• Cut off the power if there are any unexpected occurrences.
• Do not alter or modify the luminaire or change any of the components.
• Do not use the luminaire under conditions of direct sunlight
.
Technical Data
Product Name
Dimensions
Input Voltage Fr eque nc y
PowerConsumption
InstallationMethod
LED Panel Light
303x1213mm
120-277Vac 50-60Hz
40W
603x603mm
120-277Vac 50-60Hz
40W
603x1213mm
120-277Vac 50-60Hz
50W
WireConnection
Installation Instruction
Recessed In Plaster Or Grid Ceilings
Surface-Mounted Installation
Utilization of EarthquakeClips
panel until facingperpendicular
to the panelsurface.
①
Pull earthquake clip away from
②
Bend earthquake clip 90°.
③
Install panel light on grid supports.
①
Assemble the mounting brackets.
②
Drill 4 small holes in the ceiling
surface, and then install the
rubber plugs and the brackets
in the ceiling.
③ Remove one side of the brackets.
④
Connect the panel light to an
incoming power line.
⑤
Install the panel light into the
brackets.
⑥
Install the remaining side of the
bracket.
Non-Dimmable 0/1-10vdc Dimmable
LISTED
LED lum inaire
Recessed in plaster or
grid ceiling
Utilization of earthquake
Clips
Surface mounted
⑤
Lay in thepanel lighton
the ceiling surface or
grid.
①
For installation in plaster
ceilings, cut an opening
of the appropriate size,
and then connect the
panel light to anincoming
power line.
②
Using the toggle
switch(located in the
j-box), tune to the
desired color
temperature.
③
Rotate the panel light
by 45degrees.
④
Pass the panel through
the ceilingsurface.
SKU 348-0123
5 YEAR LIMITED WARRANTY