Instructions / Assembly

6
NOTE: SOME VEHICLES REQUIRE THE KEY TO BE ON ACC POSITION TO
ACTIVATE THE 12V DC ACCESSORY OUTLET.
TO PREVENT OVERCHARGING DO NOT CHARGE FOR MORE THAN 8
HOURS CONTINUOUSLY.
SAFETY PRECAUTIONS
The DC charging adapter can be used in most vehicles by plugging into the
12V DC cigarette lighter or accessory power socket.
Store in dry location and do not allow the charging adapter to come in
contact with water, rain or snow.
If the charging adapter comes in contact with water, place in a dry location at
room temperature, on a soft absorbent towel and allow to dry thoroughly.
Do not operate the unit until is completely free of moisture.
Use only the DC charging adapter supplied with the unit. Do not attempt to
charge the Safety Hammer with an adapter that is not compatible as this
could result in a fire, damage to the light or personal injury.
SAFETY PRECAUTIONS
Recharge the unit indoors in a dry location only. Exposure to damp or wet
conditions could cause a shock or damage to the unit.
Do not recharge the unit near flammable liquids or materials.
Store in dry location and do not allow the charging cables to come in come in
contact with water, rain or snow.
If the charging adapters/cables come in contact with water, place in a dry
location at room temperature, on a soft absorbent towel and allow to dry
thoroughly.
Do not operate the unit until is completely free of moisture.
Use only the charging adapter supplied with the unit. Do not attempt to
charge the Safety Hammer Tool with an adapter that is not compatible as this
could result in a fire, damage to the light or personal injury.
USB CHARGING INSTRUCTIONS
1. Unscrew the bottom of the Hammer Tool by rotating the base counter
clock wise.
2. Plug the charging cable jack into the charging port on the bottom of the
hammer tool next to the charging indicator LED.
3. Connect the USB charging cable to a USB power port.
4. The charging indicator light will glow RED while charging is in progress.
5. The battery will be fully charged after approximately 5-6 hours and the
RED charging indicator light will turn GREEN when the unit is fully charged.
6. Disconnect the charging cable from the unit first and then the other end
from the USB power port.