FL-1000 Use and Care Manual
Table of Contents INSTALLATION 3. 3. 3. Location Mounting and Installation Connecting the Power SETUP 4. 5. 6. 7. 8. 9. 10.
Installation Location ➢ Select a location at least 6 inches or more after the main shutoff for the installation of the FL-1000 sensor. Make sure that the location you select in the main line after the shutoff valve is before the pipe branches off. Mounting and Installation (It is Strongly advised to contract a certified plumber) 1. Shut off the main valve that feeds the water to the house. See diagram 1 2. Cut a one inch piece out of the PEX water pipe(keep the piece you cut out). See diagram 2 3.
Communicating with the FL-1000 There are two ways to communicate with the FL-1000 over WIFI: Option 1: Connect to the FL-1000 as a WIFI network While standing within 50 feet of the FL-1000 unit with a smart device. Look for local WIFI network named FL-1000_xxxxxx = the last four characters of the specific FL-1000’s MAC address. Example: FL-1000_030768. See Diagram 1 Below.
FL-1000 User Interface Configure Button- This button will bring you to the communications configuration page. See next page. Freeze Set Point- The temperature that is set by user. When the water Temperature goes below this value an alarm is triggered and an email and or a text are sent. Leak Alarm Status- This is triggered when a leak is detected. Am email and or a text are sent. Freeze Alarm Status- This is triggered when the water temperature goes below the Freeze set point.
Communications Configuration Page WiFI Station- This menu is where you configure and connect to your home local WIFI network WiFi Access Point- This menu is where you configure your communication parameters for the FL-1000 WIFI network.
FL-1000 User APP The APP can be downloaded for free and used to Access the specific controller locally via the local FL-1000 user interface access point or globally over the internet
Pre-Delivery/Install Checklist 1) FL-1000 Leak/Freeze Sensor 2) 24 VDC power Adapter 8
Troubleshooting No Can you see the FL-1000 network on your smart device The unit is defective. Yes Can you connect to the FL1000 network with your smart device No Reboot the FL-1000 If after rebooting the unit you still cannot see the FL-1000 network or connect to it the unit is defective. Yes Try to connect to the FL-1000 User Interface.
Warranty and Disclaimers WARRANTY Mani Group warrants that each product will be free of defects in material and workmanship for a period of three (3) years for its products. The warranty commences on the date the product is shipped by Mani Group. Mani Group’s sole liability and responsibility under this warranty is to repair or replace any product which is returned to it by the Buyer and which Mani Group determines does not conform to the warranty.
