Datasheet

Page 4 of 8 QR-QE-20/2003.08.01
Push the slide bars to any direction
推動滑柄向任何方向
9
Accuracy of
reset
position of
slide bars
滑柄復歸精度
±0.2 mm
Measure the distance between the
center of the slide bars and the center
after the slide bars pushed to the any
direction on the 2D flat and resets.
測量滑柄的中心和滑柄在 2D 平面推向任
何方向後復歸的中心的距離.
10
Terminal
strength
端子強度
Without damage or excessive
looseness of terminals or poor
contact.
端子無毀損或過度鬆動,或接觸
不良。
A force of 3N (306gf)being applied in
one direction at the tip of the terminal
for one minute and only one time to each
terminal.
以 3N(306gf)的靜力以單一方向對每一個
端子施力 1 分鐘,此測試每端子只做一次.
三. ENDURANCE CHARACTERISTICS 耐久性能(Single test of item 單一測試項目)
序號
NO.
項 目
ITEM
性 能
PERFORMANCE
測試條件
TEST CONDITIONS
1
Free falling
自由落下試驗
No damage and lever
deformation, but deformations
of terminals and molded parts
are allowed.
無不良產生,端子變形除外.
Height: 75cm
Number of falls: 3 times
從高度為 75 釐米落下測試 3 次後
2
Dry heat
耐熱性
Variation of total resistance
should be within
+5%
–30%.
To be operated mechanically.
全阻值變化要在
+5%
–30%以內，
機械方面能動作。
Temperature:+80 ±2℃
Time: 96 hours
The controller shall be subjected to
standard atmospheric conditions for 2
hours after which measurement shall be
made.
溫度在 80±2℃ 放置 96 小時.2 小時后正常
狀態下測試.