Use and Care Manual

OPERATION AND FEATURES
Remote Control
Using the Control Panel
Adjust Brightness
This function will
cycle through the
four different levels
of flame brightness.
Hold 10 seconds to
switch readout
between °F and °C.
Power
This will turn the unit
ON/OFF.Hold the power
button on the control
panel for 10 secomds to
disable or re-enable the
heater function.
Adjust Heater
This function will cycle
through the different
temperature levels
62-82℉ (17-27℃）of
the heater. Hold 3
seconds, Temperature
figure blinking and
can adjust. Default
temperature is 82℉
(27℃).
Timer
This will allow you to set
the automatic switch off
on the fireplace. Setting
can be 0.5h to 9h.
PS: The button light will
off when no opreation in
3seconds, and will light
up when press the button
again.
DLVSOD\
Display could be awake
by pressing any button.