User Manual Model : F23-17LT
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT NOTICE Please keep this user’s guide for future reference. When using electric appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. Read all instructions before using this appliance. 2. The heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. The trim around the heater outlet becomes hot during heater operation.
SITE SELECTION AND PREPARATION Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure that the power core is stored or secured to avoid tripping or snagging to reduce the risk of fire, electric shock or injury to persons. Construction and electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electric shock and injury to persons. Do not attempt to wire your own new outlets or circuits.
OPERATION AND FEATURES Adjust Brightness This function will cycle through the four different levels of flame brightness. Hold 10 seconds to switch readout between °F and°C. Using the Control Panel Timer This will allow you to set the automatic switch off on the fireplace. Setting can be 0.5h to 9h. DLVSOD\ Display could be awake by pressing any button. Adjust Heater This function will cycle through the different temperature levels 62-82℉ (17-27℃）of the heater.
CARE AND MAINTENANCE Battery Replacement •Slide the battery cover open by squeezing the release lever while pulling the battery out. Please see the underside of remote for instructions. •Replace the dead battery with one CR2025 battery. Replacement batteries are not included with the firebox. •Do not dispose of the dead battery in the municipal trash. Batteries should be disposed of at a local collection point for recycling batteries. •Close the battery cover.
Troubleshooting PROBLEM Display shows " " ROOT CAUSE The thermostat sensor is broken or disconnected. Unplug the fireplace, remove the back panel of the fireplace and check that the thermostat is plugged into the main circuit board. If this does not solve the problem contact customer service for a replacement thermostat sensor. There are no batteries. Change the remote batteries. The signal is poor. Operate remote transmitter at a slow measured pace.
Replacement Parts For replacement parts, call our customer service department Part 1 2 3 4 5 6 7 8 9 Description Front Panel Control Panel Circuit Board Flame Generator Drive Motor Main Circuit Board Thermostat Sensor Blower / Heater Assembly Flame Circuit Board Embered Circuit Board Remote Control Qty.
