SDS

FunkAway Odor Eliminator Spray - Fresh & Neutral OMC
Safety Data Sheet
according to the federal final rule of hazard communication revised on 2012 (HazCom 2012)
07/27/2017
EN (English)
3/7
6.1.1. For non-emergency personnel
Emergency procedures
:
Evacuate unnecessary personnel.
6.1.2. For emergency responders
Protective equipment
:
Equip cleanup crew with proper protection.
Emergency procedures
:
The low volatility of this product does not require ventilation. However depending on the
condition, adequate ventilation might be required.
6.2. Environmental precautions
Prevent entry to sewers and public waters.
6.3. Methods and material for containment and cleaning up
Methods for cleaning up
:
Soak up spills with inert solids, such as clay or diatomaceous earth as soon as possible. Collect
all waste in suitable and labelled containers and dispose according to local legislation. Ensure
all national/local regulations are observed.
6.4. Reference to other sections
No additional information available
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Precautions for safe handling
:
Read label before use. Obtain special instructions before use. Ensure good ventilation of the
work station. Avoid contact with eyes. Wear personal protective equipment.
Hygiene measures
:
Do not eat, drink or smoke when using this product. Always wash hands after handling the
product.
7.2. Conditions for safe storage, including any incompatibilities
Storage conditions
:
Keep out of reach of children. Keep only in the original container in well-ventilated place. Keep
container closed when not in use. Keep away from incompatible materials. Keep away from
sources of heat.
Incompatible materials
:
Oxidizing agents. Bleaching agent. Strong acids, bases.
7.3. Specific end use(s)
No additional information available
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
Ethanol (64-17-5)
ACGIH
ACGIH STEL (ppm)
1000 ppm
ACGIH
Remark (ACGIH)
URT irr
OSHA
OSHA PEL (TWA) (mg/m³)
1900 mg/m³
OSHA
OSHA PEL (TWA) (ppm)
1000 ppm
8.2. Exposure controls
Appropriate engineering controls
:
Ensure good ventilation of the work station. Emergency eye wash fountains should be available
in the immediate vicinity of any potential exposure.
Personal protective equipment
:
Handle in accordance with good industrial hygiene and safety practices. Avoid all unnecessary
exposure. For certain operations, additional Personal Protection Equipment (PPE) may be
required.
Hand protection
:
In case of repeated or prolonged contact wear gloves.
Eye protection
:
Wear goggles if splashing or spraying is anticipated.
Skin and body protection
:
In case of repeated or prolonged exposure : Personal protective clothing should be selected
based on the task being performed and the risks involved and should be approved by a
specialist before handling.
Respiratory protection
:
In case of insufficient ventilation, wear suitable respiratory equipment.
Other information
:
Do not eat, drink or smoke during use.