Instructions / Assembly

Care and Maintenance

While most powder coat ﬁnishes are tougher and much more ﬂexible than conventional solvent

based paints, they are about the same hardness as automotive paint and can scratch. To clean a

powder coated surface, use the same care and methods you would use to clean your car. Gently

wash with a clean, soft cloth and a mild detergent followed by a clear water rinse. Even though

most powder coatings are highly resistant, certain solvents can harm them. Avoid contact with

nail polish remover, paint or lacquer thinner, motor oils, transmission and brake fluids or solvent

based cleaning fluids. If any of these should contact the powder coated surface, immediately

wipe the area with a soft, clean cloth, and wash as described above.

10-year Limited Warranty

MADDEN MANUFACTURING

EZ HANDRAIL LIMITED WARRANTY

1. For a time of 10 years the manufacture warrants that EZ Handrail will not peel or blister as a direct result of defects solely arising

from its manufacture process.

Notice of Claims

To procure performance of Madden Manufacturing ‘s obligation under this warranty, you must simply notify Madden Manufacturing of

your claim within thirty (30) days after the occurrence of damage covered by this warranty. Your notice must be in writing, mailed by

certified mail or delivered to Madden Manufacturing, Warranty Service (PO Box 466 Lake Ozark, MO 65049).

This notice must (a) describe the defect claimed to exist, (b) give your name as it appears on this warranty, (c) give the purchase date

and the name and address of the contractor who installed the product, and (d) include proof of purchase.

Inspection

Madden Manufacturing shall be given a reasonable opportunity to inspect the alleged defect on the property, or it may require a sample

of the installed material sent in, before any repair, refinishing or replacement is begun. Madden Manufacturing or its appointee shall

perform its inspection within one hundred twenty (120) days after receiving notice of the claim unless prevented by weather or other

causes not under its reasonable control in which case Madden Manufacturing will inspect within a reasonable time.

Settlement

If after inspection it is determined that your claim is covered by this warranty, Madden Manufacturing shall, at its option, either, (a)

repair, (b) refinish or (c) replace those panels found to have the defects warranted against or pay an amount in cash equivalent to the

cost of the remedy elected by Madden Manufacturing based upon Madden Manufacturing reserves the right to discontinue any of its

products or make any changes in any of items products or make any changes in any of its products during the term of this warranty. If

the products covered by this warranty are not available, Madden Manufacturing shall have the right to substitute a product that, in

Madden Manufacturing’s sole discretion, is of equal quality or value. It is recognized that, in the event of such substitution, a perfect

match may not always be possible. Your rights under this warranty shall end when Madden Manufacturing makes a repair, refinishing,

replacement or payment under this warranty.

Limitations

Madden Manufacturing cannot be responsible for damages from causes outside of its control. The following are samples of external

causes of product failure which are not manufacturing defects and which are not covered by this warranty:

(a) Normal weathering: normal weathering is defined as exposure to sunlight and extremes of weather and atmosphere which will

cause any colored or painted surface to gradually fade, chalk or suffer an accumulation of surface dirt, stains or fungus. The