Instructions / Assembly

Tip#4: Elongating (enlarging) the picket fastener holes on top and bottom rails makes

assembly easier

Stair runs may require elongated (enlarged) holes

and/or shorter fasteners to secure pickets efficiently

(shorter 1” fasteners are included with the EZ Pivot

Mount Kits).

To elongate holes, use a 13/64” drill bit in an up

and down motion within the existing hole and

parallel with the rail. IMPORTANT: elongate the

hole towards the point (tip) of the mitered picket to

avoid any visible modifications. Do not widen the

holes side to side.