Full Product Manual

Fig. 8
(Fig 8.)
12
To connect the hoses to the water faucets:
Connect the straight end of each hose to the cold or hot faucet.
Turn the fittings by hand until they are tight, and then tighten
them by just an additional two-thirds of a turn with a wrench.
Do not over tighten the fittings. They can be damaged.
When done, pull the water hoses up and down to check if they
are properly connected.
Make sure that there are no kinks in the hose and that they are not crushed.
(Fig.7).
After connecting inlet hose to water faucet, turn on the water faucets to flush
out foreign substances (dirt, sand or sawdust) in the water lines. Let water
drain into bucket and check the water temperature.
After completing connection, if water leaks from the hose, repeat the same
steps. Use the most conventional type of faucet for water supply. In case the
faucet is square or too big, remove the spacing ring before inserting the faucet
into the adaptor.