All-in-One Combo Washer-Dryer BUILT-IN MODEL: EZ 4600 C
13 25 27
Built-in Installation. Can be completely built-in in place of a standard dishwasher, with 0 clearance at the back and sides.
Equator Appliances Equator Appliances Equator Appliances Equator Appliances 2
rods Moving of product without installation of shipping rods. 9.
Equator Appliances 4
EZ 4600 C 5
6
CONDENSING DRYING: 7
Parts 8
9
Super Combo Super Combo Super Combo 10
Fig.
To connect the hoses to the water faucets: Connect the straight end of each hose to the cold or hot faucet. Turn the fittings by hand until they are tight, and then tighten them by just an additional two-thirds of a turn with a wrench. Do not over tighten the fittings. They can be damaged. When done, pull the water hoses up and down to check if they are properly connected. Make sure that there are no kinks in the hose and that they are not crushed. (Fig.7).
Recommended cycles according to the laundry type. Wash Features Dry Features Water Temp Spin rpm Duration Max.
0 Minimum Installation Clearances When installed in alcove: Sides, Rear, Top = 0” (0cm) When installed in closet: Sides, Rear, Top = 0” (0cm), Front = 1” (2.54cm) Consideration must be given to provide adequate clearance for installation and service. Mobile Home Installation Installation must conform to Standard for Mobile Homes, ANSI A119.1 and National Mobile home Construction and Safety Standards Act of 1974 (PL93-383). The appliance must be attached to the floor according to ADA Compliance given below.
(Fig. 10) Fig.
16
17
Colored LED Display To display the information of selected program, such as the water temperature, spin speed, remaining time, rinse times, wash cycles and error messages. Wash + Dry button To select Wash & Dry cycle together. Extra Rinse button To add an extra rinse to the selected cycle, touch Wash + Dry and Wash only buttons for 3 seconds before starting. Wash only button To select Wash cycle only. Dry only button To select Dry cycle only.
Run the cycle A. How to run WASH + DRY Cycle Default cycle is NORMAL - If required you can change to desired washing and drying cycle based on the type of clothes by rotating the Program Dial knob. B. How to run WASH Only Cycle C. How to run DRY Only Cycle Default cycle is NORMAL - If required you can change to desired drying cycle based on the type of clothes by rotating the Program Dial knob. D. How to stop the wash cycle 1. 2.
3 How to winterize for cold weather Pour 2 cups of RV type Antifreeze in soap dispenser. Select WINTERIZE cycle on knob and press START. Machine will Rinse & Spin. Open coin trap once cycle is finished and drain out remaining water. Shut off water at both faucets and disconnect water inlet hoses from faucets and drain.
Cleaning the coin trap Switch off the appliance, allow the water to cool down. Open the service flap by using a finger (bottom right corner) (Fig. 11). (Fig. 12) (Fig. 13) Insert the coin-trap cover and screw tight, close the service flap (Fig. 14) Fig. 11 Fig. 12 Fig. 13 Fig. 14 Cleaning the Detergent drawers and Recess (Fig. 15) (Fig. 16 & Fig. 17) Fig. 15 Fig. 16 Fig. 17 Clean the machine 1. Exterior Proper care of appliance can extend its life.
Clean the water inlet filter If water is very hard or contains traces of lime deposit, the water filter may become clogged. It is therefore a good idea to clean it from time to time. Turn off the water faucet (Fig. 18). Unscrew the water inlet hose (Fig.19). Clean the filter using a hard bristle brush under the running water (Fig.20). Insert the filter into the valve and tighten up the inlet hose (Fig. 21). Fig. 18 Fig. 19 Fig. 20 Fig.
23
24
25
26
27
