User Manual

A B

Assemble the motor to the motor mount as this photo. Glue this two pcs of ply woods as motor mount base by CA glue.

C D

Assemble the motor mount and plywood base by 4 pcs of Start to assemble the motor plywood mounting as this photo.

claw nuts.

E F

There are total 8 pcs of plywood of the motor mount, After assemble the whole motor mount, use CA glue to secure

make sure down thrust angle as show on this photo. on all joins.

Page. 1

PAGE 1
A B Assemble the motor to the motor mount as this photo. Glue this two pcs of ply woods as motor mount base by CA glue. C D Assemble the motor mount and plywood base by 4 pcs of Start to assemble the motor plywood mounting as this photo. claw nuts. E F There are total 8 pcs of plywood of the motor mount, After assemble the whole motor mount, use CA glue to secure make sure down thrust angle as show on this photo. on all joins. Page.
PAGE 2
G H Use hot glue to assemble the tail fuselage. I Slide in the whole mount unit and ESC from the rear of wings. J Rc receiver and wings servo should install into one side of the Video transmitter and another wing servo should install on wing. another side of wing. K L 4 pcs of plywood skies and one pc of battery strip plywood GoPro or similar action and FPV camera on the nose. plate install under the wings by hot glue. GoPro should fixed by Velcro.
PAGE 3
M N Use the provided pushrod to link in between the servo arm Use the bottom control plate click to secure the horn. and elevon control horn. O P Both side of wing tips secure by hot glue or tape. Set and balance the CG 15cm behind the nose or just on the middle of two front finger holes under the wings. Q R Assemble the top cover and nose cover by hot glue as wings Slide the canopy into the tail fuselage, make sure it secure for canopy. flight. Use tape to secure it if necessary.