Instructions / Assembly
10
Care and Cleaning
CLEANING THE PANELS
□ Always clean the panels of the dehumidifier with a soft damp cloth. Do not use abrasive cleaners or spray
liquids on the surface of the panels.
□ Do not clean the dehumidifier or the unit parts with flammable liquids. The fumes can create a fire hazard.
□ Every few weeks, clean the water tank using nonabrasive cleaners to prevent the growth of mold, mildew, and
bacteria.
□ Partially fill the bucket with clean water and add a little mold detergent.
□ Move the solution around in the water tank. Empty the water tank, rinse, and dry.
CLEANING THE WATER TANK
WARNING: Do not clean the water tank using a dishwasher.
CAUTION: Press power button to the OFF position (“o”) and unplug the power supply cord from the wall outlet before cleaning the unit.
Troubleshooting
The unit does not
start operation.
□ The water tank may be full with water. Remove the tank and drain the water.
□ The power supply cord may not be connected properly. Connect the power supply
cord properly into a grounded wall outlet.
□ The water tank is not securely placed into its correct position. The unit will not
operate unless the water tank is inserted securely.
□ The house fuse may be blown or the circuit breaker may have tripped. Contact a
qualified service technician and replace the fuse with a time delay type or reset
the circuit breaker.
□ The unit may have been turned on/off too quickly. Turn the unit off and wait 3
minutes before restarting.
The unit does not
dry the air as it
should.
□ The air flow may be restricted. Verify that nothing is blocking the air inlet and
outlet.
□ The doors and windows may be open. Close all the doors and windows.
□ The room temperature may be too low. Increase the room temperature using
another heat source if necessary.
□ The area surrounding the unit may be too large. Use the unit in a smaller area.
The red LED light
stays on.
□ The water tank may not be secured into its proper position. Reinstall the tank into
its correct position.
Noise when the
unit is in operation.
□ The surface may not be level or flat. Place the unit on a flat or level surface.
11 www.mcappliance.com
Please contact 1-888-775-0202 for further assistance.