Manual

54
DXi User Manual
Chapter 7: Reports and Diagnostics
Sensor Status
The Sensor Status test displays critical information about each device attached to the
system.
Program Test
The Program Test turns on every station within a particular program for the specified
Duration (minutes: seconds).
to select a Program to test.
to set the duration for each station of the program in the test.
Start Now to start the Program test.
Previous to test the previous station again.
Next to switch to the next station in the program.
Associated MV's or Pumps will not be activated during Program Test.
Display Test
The Display Test turns on ever pixel on the display to ensure every pixel is
functioning.
Flow 1: 5.0000 Hz
Flow 2: 5.0000 Hz
Flow 3: 5.0000 Hz
Rain: 16 pulses
Wind: 4.0000 MPH
ET: 3 pulses
Alarm 1-3: Op, Op, Op
Current: 1.0000 Amps
Sensor Status Status WED 5:43:40 PM
Test Program 001
Duration 00:07
Start Now
Previous Next
Status: Test Running: 11
Flow: 0 (GPM) Cur:0.02
Program Test WED 5:43:40 PM
Display Test:
Initiate Test
Display Test WED 5:43:40 PM