Manual

DXi User Manual

Chapter 5: Program Entry

Irrigation Program: Yes or No. Defines if the program is a program that runs

irrigation (sprinklers, sprays, rotors, etc.) or a non-irrigation program used to control

non-irrigation items (lighting, fountain, etc.).

Rain Hold events will only suspend operation of irrigation programs and not

non-irrigation programs. Non-irrigation programs will also not be effected

by Flow related alarms such as: Main Line Limit, Unscheduled Flow, Monthly

Water Limit, or station flow alarms.

Omit by Date: Yes or No.

If set to Yes, the specified program will not irrigate on days set under the Omit

by Date/s command, under Setup-->Omit by Date.

If set to No, any and all Omit by Date/s will be ignored.

Overlap Protection: Yes or No. Overlap protection prevents programs from running

on top of each other. This is handy to prevent too many stations from activating at

once and also to prevent two programs activating the same station at the same time.

Continuous Cycle: Yes or No. Continuous Cycle runs an irrigation program over

and over again during a user-defined Cycle Start and End time. The Cycle Delay is

how long the cycle waits, in minutes, before starting again. It is similar to setting Cycle

and Soak for an individual station, but for an entire program.

If Continuous Cycle is turned on for a program, it is necessary to go back to

the program's

Start Times

and define the

Cycle Start

and

Cycle

End

times

A twelve hour water window dened during which

Program 1 will run over and over.

Over-Water Limit: Warning or Stop. If the monthly irrigation limit is exceeded, this

option determines if the DXi controller generates an alert (but keeps irrigating) or

stops watering completely.

Moisture Sensing: Yes or No. Moisture sensing enables data logging and collection

of moisture data. For complete installation and setup instructions for a moisture

sensor, please see Toro document 373-1021, TW-DAC-SOIL Moisture Sensor

Installation Guide.

Cycle Start / End

06:30AM 06:30PM

Program 1 Start Times WED 5:43:40 PM