Manual

41
DXi User Manual
Chapter 5: Program Entry
Run Times
The DXi controller allows the user to individually set a run time for each station. The
procedure to set Run Times was covered in Chapter 3: Quick Start .
To switch between entering run times in hours:minutes vs minutes:seconds,
see OPT INs, page 43.
Quick Stations
Quick Stations allow the user to quickly enter a run time for a range of stations
instead of individually assigning them as done in chapter 3.
This is handy for stations that share similar vegetation type and sun exposure.
Steps
1. to enter the first Station Range field.
2. to change the value of the first station. to set.
3. to switch to the second Station Range field. to enter.
4. to change the value of the second station. to set.
5. to switch to the Run Time field. to enter.
6. to change the run time value. to set.
7. to switch to the Apply Changes field.
8. to execute.
Station 1 Station 4
00:10 00:10
Station 2 Station 5
00:10 00:10
Station 3 Station 6
00:10 00:10
Program 1 Run Times WED 5:43:40 PM
|1-6|7-12|13-18|19-24|25-30|>
Times are in HH:MM
Station Range 001 - 010
Run Time 00:10
Apply Changes
Program 1 Quick Stations WED 5:43:40 PM