Manual

148
DXi User Manual
Glossary
devices. The term is used interchangeably with "satellite".
Controller Address
Identifies each controller/satellite within a multiple controller system. The address
number is alternately displayed on the base screen with the program number.
Current Limits
The maximum amount of current that a station is allowed to draw. If the specified
maximum current is exceeded, the station will shut down and the program advances
to the next station. Also refers to the minimum amount of current that a station
should be drawing. If a station output does not draw any current, it is likely that the
circuit is open.
Cycle Mode
Option that selects either start times or continuous cycle.
Device
Defined in an irrigation system configuration as a Master Valve, Pump or Flow Sensor.
Decoder
A device on the 2-Wire path that activates solenoids based off commands from a
controller. Depending on the decoder type it can activate stations, MV's, Pumps, read
flow sensors or read moisture sensors.
EvapoTranspiration (ET)
The name reflects two ways water moves from an irrigated field to the atmosphere:
Evaporation, which is the movement of water from the wet soil to the air, and
Transpiration which is the movement of water from the plant to the air.
EV-CAB-COM
A particular type of communication cable used in controller hardwire configurations.
EV-CAB-SEN
A particular type of cable for sensor connections to a controller.
Field Wiring
The wiring setup among controllers, Master Valves, Pumps, sensors, and valve solenoids.
Flow Check Delay
The specified time period prior to taking flow measurements (range from 2 to 6
minutes) to allow for water line stabilization.